Extended ACLs

Extended ACLs

In this post I will create an Extended ACL to block Telnet traffic from the 192.168.1.48/30 network reaching the R3 router. I'll be working with the network in the diagram below.



Unlike Standard ACL's which are placed as near to the destination as possible, Extended ACL's are placed as near to the source as possible, this is to reduce processing on the routers.


R1


R1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#ip access-list extended 100
R1(config-ext-nacl)#deny 192.168.1.48 0.0.0.3 192.168.1.58 0.0.0.0 eq 23 log
R1(config-ext-nacl)#permit ip any any log
R1(config-ext-nacl)#exit


I have created an access-list to block all the 192.168.1.48/30 subnet from access R3 with Telnet.


R1(config-if)#ip access-group 100 in
R1(config-if)#end


I have applied the list to interface ethernet 0/0 on R1


R1#sh ip inter ethernet 0/0
Ethernet0/0 is up, line protocol is up
Internet address is 192.168.1.50/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.9
Outgoing access list is not set
Inbound access list is 100
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF Feature Fast switching turbo vector
IP multicast fast switching is enabled

I test that I can telnet to R3 from R1.


R1#telnet 192.168.1.58
Trying 192.168.1.58 ... Open
User Access Verification
Password:
Last login: Wed Mar 3 21:06:01 on ttys001


Now on R0 I attempt to telnet to R3


R0

R0#telnet 192.168.1.58
Trying 192.168.1.58 ...
% Destination unreachable; gateway or host down

R0#ping 192.168.1.58
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.58, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/11/16 ms


My telnet fails but ping works just fine. I check R1 to see the statement being hit.


R1

*Mar 1 00:10:52.315: %SEC-6-IPACCESSLOGP: list 100 denied tcp 192.168.1.49(22404) -> 192.168.1.58(23), 1 packet
R1#
*Mar 1 00:11:02.615: %SEC-6-IPACCESSLOGDP: list 100 permitted icmp 192.168.1.49 -> 192.168.1.58 (8/0), 1 packet
R1#